7-Foot Garage Door TorqueMaster-to-Standard Torsion Spring Conversion Kit

Product Description

This garage door conversion kit is designed to convert a 7-foot-high Wayne Dalton TorqueMaster, EZ-Set or similar enclosed spring system to a conventional exposed torsion spring setup.

The kit includes the primary drums, bearing components, lift cables and mounting hardware required for the conversion. Converting to a standard torsion system makes future spring inspection, adjustment and replacement easier because conventional torsion components are more widely available.

Features

• Designed for 7-foot-high residential garage doors
• Converts TorqueMaster or EZ-Set systems to standard torsion
• Supports a conventional exposed torsion spring configuration
• Includes standard-lift cable drums
• Includes residential end bearing plates
• Includes a nylon center bushing
• Includes 7-foot lift cables
• Includes a spring anchor plate
• Includes assorted installation fasteners
• Suitable for garage door repair and modernization projects

Package Contents

• Standard-lift cable drums
• Residential end bearing plates
• Nylon center bushing
• 7-foot garage door lift cables
• Spring anchor plate
• Assorted installation fasteners

Compatibility & Fitment

Designed for a 7-foot-high residential sectional garage door currently equipped with a TorqueMaster, EZ-Set or comparable proprietary spring system.

Before ordering, verify:

• Garage door height
• Garage door width
• Actual door weight
• Existing spring-system type
• Standard-lift track configuration
• Required torsion shaft length
• Required torsion spring size
• Lift-cable routing and condition

This kit is primarily intended for standard-lift residential garage doors. High-lift, vertical-lift, low-headroom and specialty track systems may require different drums, cables or additional hardware.

Important Matching Notes

This conversion kit does not include or determine the correct torsion springs.

Torsion springs must be calculated according to the actual garage door weight, door height, cable drums, track configuration and desired cycle life. Do not select replacement torsion springs solely by comparing them with the original TorqueMaster springs.

When the original spring specifications are unavailable, the garage door should be weighed before ordering new torsion springs.

Parts Not Included

• Torsion springs
• Torsion shaft or tube
• Spring winding bars
• Garage door tracks
• Garage door panels
• Automatic garage door opener

The torsion shaft and springs are sold separately.

Installation Notes

The original TorqueMaster or EZ-Set spring system must be fully unloaded and safely removed before installing the standard torsion components.

The end bearing plates, center spring anchor plate, torsion shaft, cable drums, lift cables and springs must be correctly aligned before the springs are wound. Both lift cables must carry equal tension, and the garage door must remain level throughout operation.

Additional hardware or modifications may be required depending on the existing garage door and track configuration.

Safety Warning

Garage door spring systems operate under extreme tension and can cause serious injury or death.

Do not disassemble a TorqueMaster system or install and wind torsion springs without the proper tools, training and procedures. Installation should be performed by a qualified garage door technician.

SEO Title: 7-Foot TorqueMaster to Standard Torsion Spring Conversion Kit

Meta Description: Convert a 7-foot-high TorqueMaster or EZ-Set garage door spring system to standard torsion. Includes drums, bearing plates, lift cables, center bushing, spring anchor plate and installation fasteners.