SSC .2625 x 1.75" ID x 35.25" Torsion Spring – Right Wind (RW) – Blue

🇺🇸 Made in USA

This SSC torsion spring is manufactured for sectional garage door systems requiring a .2625" wire diameter, 1.75" inside diameter, 35.25" spring length, and right-wind configuration.

Manufactured from coated, oil-tempered spring wire, this spring comes with the winding cone and stationary cone pre-installed and is rated for an industry-standard minimum of 10,000 operating cycles.

Specifications

Blue Wire Color Code

For this spring:

Blue = .2625" wire diameter

The color marking is an identification aid only and should not be used by itself to select a replacement spring.

Always verify the actual wire diameter, inside diameter, spring length, and wind direction before ordering.

Right-Wind Configuration

This is a Right-Wind (RW) torsion spring.

On many standard two-spring systems, the right-wind spring is typically installed on the left side of the center support when viewed from inside the garage looking toward the door.

Garage door configurations vary, so always verify the actual winding direction of the spring being replaced.

Cones Pre-Installed

This spring includes:

• Winding cone installed

• Stationary cone installed

The winding cone is used to apply spring tension with proper winding bars.

The stationary cone secures the spring to the center bearing plate or spring anchor bracket.

Application

This torsion spring is intended for compatible sectional garage doors using a torsion-shaft counterbalance system.

Typical applications include:

• Residential sectional garage doors

• Heavy residential garage doors

• Insulated sectional doors

• Light-commercial sectional doors

• Replacement of a broken torsion spring

• Preventive spring replacement

• Standard-lift torsion systems

• Properly engineered high-lift applications

Compatibility & Fitment

Torsion springs are not universal.

For correct replacement, verify:

• Wire diameter: .2625"

• Inside diameter: 1.75"

• Spring length: 35.25"

• Wind direction: Right Wind

• Door weight

• Door height

• Cable drum type

• Track configuration

• Number of springs

• Required torque / IPPT

Even small differences in wire size, inside diameter, or spring length can significantly change the amount of torque produced.

Important Matching Notes

For two-spring systems, both springs must work together as a correctly engineered counterbalance pair.

Verify:

• Correct RW/LW pairing

• Matching spring torque

• Cable drum size

• Door weight

• Standard-lift, high-lift, or vertical-lift configuration

• Available spring space

High-lift and vertical-lift systems require spring selection based on the actual drum and track geometry.

Standard Cycle Spring

This is a standard coated torsion spring, not an SSC Extended Cycle / DuraMaster spring.

The spring is rated for an industry-standard minimum of 10,000 cycles when properly selected, installed, and used on a correctly balanced garage door.

Ready to Order?

If your garage door requires a .2625" wire × 1.75" ID × 35.25" Right-Wind torsion spring, this SSC spring provides a professional-grade replacement with winding and stationary cones already installed.

Verify all dimensions, wind direction, drum configuration, and required torque before ordering.

Safety Warning

⚠️ Garage door torsion springs are under extreme stored energy.

Installation, removal, winding, or adjustment can cause serious injury or property damage if performed incorrectly.

Use proper winding bars and professional garage-door service procedures. Installation by a qualified garage door technician is strongly recommended.