SSC .2500 x 1.75" ID x 37.25" Torsion Spring – Right Wind (RW) – Gold

🇺🇸 Made in USA

This SSC torsion spring is manufactured for sectional garage door systems requiring a .2500" wire diameter, 1.75" inside diameter, 37.25" spring length, and right-wind configuration.

Manufactured by Service Spring Corporation (SSC) from coated, oil-tempered spring wire, this spring is designed for properly matched residential and light-commercial torsion systems and carries an industry-standard minimum rating of 10,000 cycles.

Specifications

Gold Wire Color Code

For this spring:

Gold = .2500" wire diameter

The color marking is an identification aid only.

Always verify the actual wire diameter, inside diameter, spring length, and wind direction before ordering.

Right-Wind Configuration

This is a Right-Wind (RW) torsion spring.

On many standard two-spring systems, the right-wind spring is typically installed on the left side of the center support when viewed from inside the garage looking toward the door.

Garage door configurations vary, so always verify the actual winding direction of the existing spring.

Application

This torsion spring is intended for compatible sectional garage doors using a torsion-shaft counterbalance system.

Typical applications include:

• Residential sectional garage doors

• Heavy residential doors

• Light-commercial sectional doors

• Replacement of a broken torsion spring

• Preventive spring replacement

• Standard-lift torsion systems

• Properly engineered high-lift systems

Compatibility & Fitment

Torsion springs are not universal.

For correct replacement, verify:

• Wire diameter: .2500"

• Inside diameter: 1.75"

• Spring length: 37.25"

• Wind direction: Right Wind

• Door weight

• Door height

• Cable drum type

• Track configuration

• Number of springs

• Required torque / IPPT

A spring with similar dimensions can still produce different torque if the wire size, ID, or length differs.

Important Matching Notes

For two-spring systems, both springs must work together as a properly engineered pair.

Verify:

• Correct RW/LW pairing

• Matching spring torque

• Cable drum size

• Door weight

• Standard-lift, high-lift, or vertical-lift configuration

• Available spring space

High-lift and vertical-lift systems require spring selection based on the actual drum and track geometry.

Standard Cycle Spring

This is a standard coated torsion spring, not an SSC Extended Cycle / DuraMaster spring.

The published minimum is 10,000 cycles when correctly selected and installed.

Why Correct Spring Selection Matters

The torsion spring counterbalances most of the garage door’s weight.

A correctly sized and properly wound spring helps:

• Keep the door balanced

• Reduce load on the opener

• Maintain cable tension

• Provide smooth opening and closing

• Reduce wear on garage door hardware

An incorrectly selected spring can make the door excessively heavy, overly light, difficult to control, or unsafe.

Ready to Order?

If your garage door system requires a .2500" wire × 1.75" ID × 37.25" Right-Wind torsion spring, this SSC spring provides a professional-grade replacement for properly matched torsion systems.

Verify all dimensions, wind direction, drum configuration, and required torque before ordering.

Safety Warning

⚠️ Garage door torsion springs are under extreme stored energy.

Installation, winding, adjustment, and removal can cause serious injury or property damage if performed incorrectly.

Use proper winding bars and professional garage-door service procedures. Installation by a qualified garage door technician is strongly recommended.