SSC .2437" × 2.00" ID × 34.00" Torsion Spring – RW – Green

🇺🇸 Made in USA

Restore the intended counterbalance on a compatible sectional garage door with this SSC right-wound torsion spring. It features .2437" wire, a 2.00" inside diameter, and a 34.00" relaxed spring-body length, with winding and stationary cones installed.

The coated, oil-tempered spring wire stores and releases torque as the door moves. When correctly matched to the application, it helps the counterbalance assembly offset door weight throughout the operating cycle and supports proper opener performance.

Specifications

Construction & What Is Included

Oil-tempered wire provides the spring material for repeated torque loading. The coating helps protect the surface, but does not eliminate environmental wear or the need for maintenance.

Both cones are installed. The winding cone provides the fitting used for professional tension adjustment, while the stationary cone secures the opposite end in a compatible anchor arrangement.

This listing includes one spring with cones. A companion spring, shaft, cable drums, cables, bearings, mounting brackets, and winding tools are separate components.

Common Uses

For professional replacement of a matching right-wound spring on a sectional garage door or use in a professionally calculated spring combination.

Selection must consider actual door weight, travel height, cable drum model, and the complete spring arrangement. Door width, opener brand, or green paint marking alone cannot establish compatibility.

Compatibility & Why Exact Length Matters

Verify .2437" wire diameter, 2.00" inside diameter, 34.00" relaxed body length, and right-hand wind before ordering.

Springs with the same wire and inside diameter but different body lengths have different spring rates. A nearby length should not be substituted simply because it fits on the shaft. The replacement must balance the door through its intended travel.

The 34.00" measurement covers the relaxed coil body only, excluding both cones. An installed spring under winding tension may measure longer than its original specification. Have measurements safely confirmed by a qualified technician.

The 2.00" ID describes the opening inside the coils, not the shaft diameter. Check cone bore, shaft fit, stationary mounting, and available assembly space separately.

Right-Hand Wind & Green Identification

RW identifies the direction of the spring coil. Green is the wire-size identification color and does not establish installation side or a universal lifting capacity.

This is the right-wound version of the 34.00" configuration. A left-wound spring with otherwise identical dimensions is not an interchangeable replacement. Select the wind required by the actual counterbalance arrangement.

Pairing, Cable Drums & Door Changes

On a two-spring door, have both springs inspected and their specifications verified. Springs with similar service histories may warrant replacement together, but the correct pair must provide the required combined torque and spring rate.

The engineered pair can use matching or different dimensions. Added insulation, overlays, replacement sections, different cable drums, or lift conversions can change the requirements. High-lift and vertical-lift applications need calculations specific to their geometry.

Cycle Life & Ongoing Care

The standard minimum rating is 10,000 cycles in a correctly selected application. One cycle is one full opening and closing. Actual lifespan depends on daily use, operating conditions, corrosion, and maintenance.

Follow the door manufacturer’s inspection and lubrication recommendations. Arrange service if the door becomes heavy, moves unevenly, or develops abnormal noise. Increasing opener force does not correct a counterbalance problem.

Professional Installation & Safety

Torsion springs store hazardous energy. Installation and tension adjustment must be performed by a qualified garage door technician using proper winding bars and manufacturer procedures.

Never loosen loaded cones, anchor brackets, drums, or bottom cable attachments. Keep a door with a broken spring out of operation. The completed repair should include supporting-hardware inspection, balance testing, cable checks, and verification of opener safety functions.

Choose this SSC right-wound spring after confirming the exact 34.00" specification and your door’s complete counterbalance requirements.