SSC .1920 x 1.75″ ID x 120″ Torsion Spring – Right Wind – Orange

🇺🇸 Made in USA

Manufactured by Service Spring Corporation (SSC), this .1920″ wire x 1.75″ inside diameter x 120″ right-wind torsion spring is intended for professionally specified long-length counterbalance applications.

The 120-inch dimension describes the listed spring body—10 feet—not a door-height recommendation. Confirm the required finished configuration and intended use before ordering this product as a replacement or for a custom application.

Features & Benefits

• .1920″ wire diameter with orange wire-size identification.

• 1.75″ inside diameter.

• Listed spring-body length: 120″.

• Right-wind configuration.

• Coated, oil-tempered wire.

• Winding and stationary cones listed as installed.

• For applications requiring a professionally verified spring design.

Specifications

Cycle Life

The listing states a standard minimum 10,000-cycle classification. The applicable rating for this long-length spring must be confirmed for the final installed design, loading, and operating turns.

A long body alone does not guarantee higher cycle life or suitability for an existing door. One full opening and closing equals one cycle.

Compatibility & Measurement

Verify .1920″ wire, 1.75″ inside diameter, right-wind direction, and the required finished body length. Establish whether the application requires the full listed length or a separately specified custom assembly.

Do not use this spring as a direct substitute for a shorter spring based only on matching wire diameter and ID. Length affects torque per turn and the resulting counterbalance.

Right wind identifies coil direction rather than installation side. Confirm the winding direction required by the actual shaft and anchor arrangement.

Check cone fit, shaft compatibility, stationary mounting, and sufficient operating clearance. Orange paint is a supporting identification clue, not a lifting-capacity rating.

Pairing & Custom Applications

Spring selection must account for door weight, height, cable drums, lift configuration, working turns, and companion springs. The combined spring output must match the complete system.

A same-size left-wind companion is appropriate only when the pair has been correctly calculated. High-lift and vertical-lift systems require separate evaluation.

Any proposed change to the supplied spring must be assessed and performed by a qualified spring professional.

Installation & Safety

Torsion springs store enough energy to cause severe injury. Installation, modification, and adjustment should be performed by trained professionals using proper tools and manufacturer procedures.

Never loosen loaded cones, drums, cables, or bottom brackets. Verify door balance throughout travel, cable alignment, spring clearances, and opener safety operation after installation.

Contact us before purchasing to confirm the supplied configuration and finished spring requirements for this 120-inch SSC right-wind product.

SSC .1920 x 1.75″ ID x 120″ Right-Wind Torsion Spring – Orange
Shop an American-made SSC long-length torsion spring with coated wire. Confirm the required finished length, winding direction, and counterbalance design before ordering.