LiftMaster 501012 /50-101-2 Exterior Pneumatic Air Switch —SPDT

LiftMaster 501012 /50-101-2 Exterior Pneumatic Air Switch —SPDT

$68.12
Skip to product information
LiftMaster 501012 /50-101-2 Exterior Pneumatic Air Switch —SPDT

LiftMaster 501012 /50-101-2 Exterior Pneumatic Air Switch —SPDT

501012
$68.12
Shipping calculated at checkout.

The LiftMaster 501012 supplier SKU identifies the 50-101-2 exterior pneumatic air switch. Manufacturer accessory literature describes the 501012 as a three-wire SPDT switch in a plastic housing, distinct from the metal-cased normally-open50101. It is one component of a compatible pneumatic edge arrangement rather than a complete edge, air hose or monitored protection system. Match the exact operator interface and edge instructions before ordering. A pneumatic switch should not be represented as a universal replacement for the primary monitored protection required by the installed operator.

Compatibility — Models, Versions and Exclusions

Model or selection point Compatibility requirement
Approved pneumatic edge arrangements Match switch, air hose and operator interface.
501012 /50-101-2 mapping Confirm current supplied version.
50101 switch Different contact and housing description.
Primary monitored protection Not replaced solely by this pneumatic switch.
Electrical contact loads Confirm exact rating and circuit; no universal load approval.

Inspect the Air Path and the Electrical Interface

Record the operator and edge-system models and photograph the installed switch, hose connection and wiring. A pneumatic edge fault can involve a leaking hose, damaged edge, poor connection or switch problem. Have qualified personnel diagnose the complete air path and electrical input rather than replacing the switch based only on a door that does not reverse as expected.

Match the exact switch-contact arrangement to the operator’s approved interface instructions. Do not transfer wiring from the normally-open metal-case version or assume that three wires establish a monitored circuit. Restore the documented hose routing and mounting without pinching or obstructing the air path. After repair, test the complete edge response and all separately required primary protection under the operator’s prescribed procedure before normal use.

Specifications and Product Identification

Specification Details
Supplier SKU 501012
Supplier part reference 50-101-2
Product Exterior pneumatic air switch
Contact arrangement SPDT /three wire
Manufacturer housing description Plastic
Different switch 50101 metal case, normally open

Before Ordering

  • Record operator and pneumatic edge arrangement.
  • Confirm 501012 /50-101-2 and SPDT three-wire version.
  • Inspect hose, edge, connections and actual switch rating.
  • Verify approved interface and separate primary protection requirements.

Package Contents and Separate Requirements

This offer identifies the 501012 exterior air switch. Pneumatic sensing edge, rubber hose, hose plugs, coil cord, take-up reel, interface module and complete operator are not promised as included. Confirm current supplied connection pieces and mounting hardware. Manufacturer accessory diagrams list those pneumatic components separately; a switch order does not establish a complete edge system or every part needed to restore a damaged installation.

Safety Warnings — Read Before Installation or Service

  • WARNING: A pneumatic edge must be connected and tested through an approved operator arrangement. Use qualified door-service personnel.
  • Isolate applicable power before switch or wiring work and secure the door against unintended movement.
  • Do not bypass required monitored protection or substitute an unverified contact arrangement. Diagnose leaks and mechanical edge faults.
  • Test the full pneumatic edge response and every required primary safety device before returning the door to normal operation.

Related Products and Important Differences

Frequently Asked Questions

Is it the normally-open50101 switch?

No.501012 is the documented three-wire SPDT version.

Is a complete edge included?

No. This offer identifies the switch.

Does three-wire mean monitored?

No. Monitoring requires the approved complete system and interface.

Can it replace required primary protection?

No such replacement is established by this accessory listing.

Need Help Confirming the Right Product?

Contact Garage-DoorParts.com before ordering. Send the full equipment model, readable part labels and photographs of the installed assembly. Include the dimensions, electrical configuration or accessory details relevant to your project so the listing can be checked against the actual installation.

Details

Need Help With Compatibility?

Not sure if this is the correct part for your garage door, operator, gate system, or application? Contact Us before ordering — we’re happy to help.

Garage-DoorParts.com carries a large selection of residential and commercial parts, and many components can look similar while having important differences in dimensions, model numbers, voltage, mounting, or compatibility.

For the best assistance, please provide as much information as possible, including the manufacturer, model number, part number, door or operator type, dimensions, and clear photos of the existing part or equipment.

Our goal is to help you identify the correct product before you order and reduce the possibility of ordering an incompatible part.

Contact Us with your product questions and compatibility information, and we’ll do our best to point you in the right direction.

Shipping & Returns

We strive to process and ship all orders in a timely manner, working diligently to ensure that your items are on their way to you as soon as possible.

We are committed to ensuring a positive shopping experience for all our customers. If for any reason you wish to return an item, we invite you to reach out to our team for assistance, and we will evaluate every return request with care and consideration.

Related products