2" Garage Door Torsion Spring Winding Cone

Complete or repair a compatible 2-inch torsion-spring assembly with this SSC winding cone. The cone installs at the active end of the spring and provides the set screws and winding-bar sockets required to apply and retain the specified spring tension.

Specifications:

• Spring inside diameter: 2"

• Cone type: Winding cone

• Maximum spring wire size: .295"

• Quantity: One winding cone

• Manufacturer: Service Spring Corporation / SSC

• Product number: 132

• Country of manufacture: Made in the USA 🇺🇸

The 2-inch measurement refers to the torsion spring’s inside diameter—not its outside diameter or the diameter of the torsion shaft. Measure the spring carefully and compare all available markings with the original cone.

This listing contains one winding cone only. The stationary cone, torsion spring, shaft, center bearing, spring anchor bracket, mounting hardware, and winding bars are not included.

Before ordering, verify the spring inside diameter, wire size, shaft configuration, cone bore, set-screw placement, and required wind configuration. Cones made for different spring sizes should not be substituted based solely on a similar appearance.

Never reuse a cone that is cracked, distorted, stripped, or damaged around the winding-bar sockets. Torsion-spring winding and cone replacement should be performed only by a qualified garage door technician using correctly sized winding bars.

Order SSC 132 when the approved application requires one winding cone for a compatible 2-inch ID torsion spring with wire no larger than .295 inch.