SSC .2253 x 2.00" ID x 120" Torsion Spring – Right Wind (RW) – Red

🇺🇸 Made in USA

This SSC long-length torsion spring is manufactured for sectional garage door systems requiring a .2253" wire diameter, 2.00" inside diameter, 120" spring length, and right-wind configuration.

Manufactured by Service Spring Corporation (SSC) from coated, oil-tempered spring wire, this 120" spring is designed for properly engineered residential, oversized, and commercial garage door counterbalance systems.

Specifications

Long-Length 120" Torsion Spring

At 120 inches long, this spring is significantly longer than the torsion springs used on many standard residential garage doors.

Long-length springs are typically selected when the counterbalance system requires a specific combination of:

• Wire diameter

• Inside diameter

• Spring torque

• Door weight

• Cable drum geometry

• Track configuration

• Available torsion-shaft space

The spring length directly affects torque characteristics, so this configuration should only be used where the garage door system has been properly calculated.

Red Wire Color Code

For this spring:

Red = .2253" wire diameter

The color marking is an identification aid only.

Always verify the actual:

• Wire diameter

• Inside diameter

• Spring length

• Wind direction

before ordering.

Right-Wind Configuration

This is a Right-Wind (RW) torsion spring.

On many conventional two-spring systems, the right-wind spring is typically installed on the left side of the center support when viewed from inside the garage looking toward the door.

Garage door configurations vary, so always verify the actual spring wind before ordering.

Application

This long-length torsion spring may be used in properly engineered applications such as:

• Heavy residential sectional doors

• Oversized garage doors

• Commercial sectional doors

• Long torsion-shaft systems

• Custom counterbalance systems

• Replacement of an existing matching spring

• Standard-lift systems

• High-lift or vertical-lift systems when properly calculated

Compatibility & Fitment

Torsion springs are not universal.

For correct replacement, verify:

• Wire diameter: .2253"

• Inside diameter: 2.00"

• Spring length: 120"

• Wind direction: Right Wind

• Door weight

• Door height

• Cable drum model

• Track configuration

• Number of springs

• Required torque / IPPT

• Available shaft space

A spring that looks similar can produce significantly different torque if its wire size, ID, or length differs.

Important Matching Notes

For two-spring or multi-spring systems, all springs must work together as a properly engineered counterbalance system.

Verify:

• Correct RW/LW pairing

• Matching spring torque

• Cable drum size

• Door weight

• Available spring space

• Standard-lift, high-lift, or vertical-lift configuration

High-lift and vertical-lift systems require spring calculations based on the actual drum and track geometry.

Standard Cycle Spring

This is a standard coated torsion spring, not an SSC Extended Cycle / DuraMaster spring.

The standard published minimum is 10,000 cycles when the spring is