SSC .2070" × 1.75" ID × 25.00" Torsion Spring – RW – Yellow

🇺🇸 Made in USA

This SSC right-wound torsion spring is designed for sectional garage door systems requiring .2070" wire, a 1.75" inside diameter, and a 25.00" relaxed spring-body length. It is manufactured from coated, oil-tempered wire and supplied with installed winding and stationary cones.

A correctly matched spring helps the counterbalance assembly offset the door’s weight throughout its movement. Proper balance supports controlled manual operation and allows the opener to move the door without compensating for an incorrectly sized spring.

Specifications

Construction & Package Contents

The spring’s oil-tempered wire is designed for repeated torsional loading during door operation. Its protective coating helps protect the surface while remaining subject to environmental exposure and normal maintenance requirements.

The winding and stationary cones are installed. Their fit must still be checked against the shaft and anchor arrangement before installation.

This listing includes one right-wound spring with cones. A companion spring, shaft, cable drums, cables, bearings, brackets, and professional installation tools are separate items.

Common Uses

For professional replacement of a matching spring on a sectional garage door or use in a professionally calculated counterbalance system.

Door width, opener model, or a yellow marking alone cannot establish compatibility. Selection must consider actual door weight, travel height, cable drums, and any other springs in the assembly.

Compatibility: Verify the 1.75" ID

Match .2070" wire, 1.75" inside diameter, 25.00" relaxed body length, and right-hand wind.

The 1.75" inside diameter distinguishes this spring from .2070" wire springs with a 2.00" ID. Different inside diameters affect spring performance and fitting requirements, so those configurations are not direct substitutes without a sizing calculation.

The 25.00" length refers to the relaxed coil body, excluding both cones. An installed spring under winding tension can measure longer than its original specification. Have measurements confirmed safely by a qualified technician.

The spring ID is not the torsion shaft diameter. Check cone bore, shaft fit, stationary mounting, and available assembly space separately.

Right-Hand Wind & Yellow Identification

RW describes the direction of the coil. Yellow is the wire-size identification color and does not establish installation side or door-weight capacity.

This is a torsion spring, so its yellow marking should not be interpreted using extension-spring weight-color conventions. Confirm the actual wire diameter and required wind rather than ordering by color alone.

Pairing & Application Changes

When servicing a two-spring door, have both springs inspected and their specifications verified. Springs with similar service histories may warrant replacement together, but the correct pair must meet the door’s combined counterbalance requirements.

The engineered pair may use equal or unequal dimensions. Added insulation, overlays, glazing, replacement sections, different drums, or lift conversions can change the required selection. High-lift and vertical-lift applications need their own calculations.

Cycle Rating & Ongoing Care

The standard minimum rating is 10,000 cycles in the correct application. One cycle is one full opening and closing. Actual lifespan depends on usage frequency, environment, maintenance, and loading.

Follow the door manufacturer’s inspection and lubrication recommendations. Seek service if the door becomes difficult to move, rises unevenly, or develops abnormal noise. An opener adjustment cannot correct an improperly sized counterbalance.

Installation & Safety

Professional installation is required. Never loosen loaded cones, anchor brackets, drums, or bottom cable attachments. Uncontrolled release of spring or cable tension can cause severe injury.

A qualified technician should use correctly fitting winding bars, inspect supporting hardware, and follow manufacturer procedures. Before returning the door to service, verify balance, cable tracking, and opener safety operation.

Choose this SSC right-wound spring after confirming the 1.75" ID, 25.00" body length, wire size, and required wind.