SSC .2343 x 2″ ID x 24″ Torsion Spring – Right Wind – Brown

Manufactured by Service Spring Corporation (SSC), this .2343″ wire x 2″ inside diameter x 24″ right-wind torsion spring is intended for a sectional door system specified for this spring configuration.
🇺🇸 Made in USA

Supplied with winding and stationary cones installed, this spring uses coated, oil-tempered wire. Its relatively short body length is an important part of its operating specification and should not be substituted with a longer spring without a proper calculation.

Features & Benefits

• .2343″ wire diameter with brown wire-size identification.

• 2″ inside diameter.

• 24″ unwound spring-body length.

• Right-wind configuration.

• Installed winding and stationary cones.

• Coated, oil-tempered wire.

• Stenciled and color-coded for identification.

• Standard-cycle spring listed for a minimum 10,000-cycle application when correctly selected.

A cycle is one complete opening and closing. Actual lifespan depends on operating turns, loading, installation, maintenance, and environmental exposure.

Specifications

Common Applications

For replacement of a matching torsion spring on a compatible sectional overhead door. Suitability depends on the door’s measured weight, height, lift configuration, cable drums, and complete spring arrangement.

A short spring body does not necessarily mean the spring is intended for a small or lightweight door.

Compatibility & Measurement

Verify .2343″ wire diameter, 2″ inside diameter, 24″ unwound body length, and right-wind direction. Confirm cone fit, shaft dimensions, stationary mounting, and available operating space.

Length is measured across the unwound coil body, excluding cones. Wound springs are longer than their relaxed length, so measurements from a tensioned spring can misidentify the replacement.

Brown paint is a wire-size identification aid. It does not establish winding direction or a universal door-weight rating.

Pairing & System Requirements

On a two-spring assembly, this spring must work with its companion to provide the required combined torque. Do not automatically choose a same-size opposite-wind spring unless that combination matches the door’s requirements.

Have the companion inspected when replacing a failed spring. A higher-cycle alternative requires a calculated change in dimensions while preserving the necessary torque output and fitting the available shaft space.

High-lift, vertical-lift, and cable-drum changes require a separate assessment.

Installation & Safety

Torsion-spring replacement should be performed by a trained garage door technician using proper tools and manufacturer procedures. Do not release spring tension simply to obtain a measurement unless professionally trained and equipped.

Never loosen loaded cones, cable drums, cables, or bottom fixtures. The installer should verify door balance, cable alignment, and opener safety operation after replacement.

Confirm the full specification and order this SSC 24-inch right-wind spring. Contact us before purchasing if you need help identifying the correct size.

SSC .2343 x 2″ ID x 24″ Right-Wind Torsion Spring – Brown
American-made SSC torsion spring with coated, oil-tempered wire and installed cones for a correctly matched sectional door counterbalance system.