SSC .295 x 1.75″ ID x 56″ Torsion Spring – Left Wind – White

🇺🇸 Made in USA

Manufactured by Service Spring Corporation (SSC), this .295″ wire x 1.75″ inside diameter x 56″ left-wind torsion spring is intended for sectional door systems requiring this specific spring configuration.

The spring features coated, oil-tempered wire and includes installed winding and stationary cones. Its 56-inch body length is an essential part of its operating specification and must be considered when checking both spring performance and available installation space.

Features & Benefits

• .295″ wire diameter with white wire-size identification.

• 1.75″ inside diameter.

• 56″ unwound spring-body length, excluding cones.

• Left-wind configuration.

• Installed winding and stationary cones.

• Coated, oil-tempered wire.

• Stenciled and color-coded for identification.

• Standard-cycle spring listed for a minimum 10,000-cycle application when correctly selected.

A cycle consists of one complete opening and closing. Actual service life depends on loading, operating turns, installation, maintenance, and environmental conditions.

Specifications

Common Applications

For replacement of a matching spring on a compatible sectional overhead door. Door weight and height, drum geometry, track configuration, and the complete spring combination determine suitability.

The spring’s length does not identify the door height or automatically classify it as an extended-cycle replacement.

Compatibility & Measurement

Verify .295″ wire, 1.75″ inside diameter, 56″ unwound body length, and left wind. Confirm cone and shaft fit, stationary mounting, and sufficient clearance along the shaft.

Allow for the cones and the spring’s length change during winding. The 56-inch body measurement alone does not represent the complete operating space required.

White wire-size markings are also used for other spring sizes. A white-marked spring with a different wire diameter is not an equivalent replacement. Confirm physical measurements rather than relying on paint color.

Pairing & Replacement Options

On a two-spring system, the springs must produce the correct combined torque. The companion may be an equal-size opposite-wind spring or a different size specified by the design.

Have the companion evaluated when replacing a failed spring. Higher-cycle alternatives require a calculated size change that preserves the required operating characteristics and fits the available shaft.

High-lift tracks, vertical-lift operation, or changes to cable drums require a separate spring calculation.

Installation & Safety

Torsion-spring replacement should be performed by a trained garage door technician using proper tools and manufacturer procedures.

Never loosen loaded cones, drums, cables, or bottom fixtures. After replacement, verify balance throughout travel, cable tracking, spring clearances, and opener safety operation before normal use.

Confirm your measurements and available shaft space, then order this SSC 56-inch left-wind spring. Contact us if you need help checking the complete replacement specification.

SSC .295 x 1.75″ ID x 56″ Left-Wind Torsion Spring – White
American-made SSC torsion spring with coated, oil-tempered wire and installed cones. Verify exact wire size, winding direction, and installation clearance.