SSC .2625 x 2″ ID x 33.5″ Torsion Spring – Left Wind – Blue

Manufactured by Service Spring Corporation (SSC), this .2625″ wire x 2″ inside diameter x 33.5″ left-wind torsion spring is intended for sectional door systems requiring this exact spring size and winding direction.
🇺🇸 Made in USA

The spring includes installed winding and stationary cones and features coated, oil-tempered wire. Correct selection provides the counterbalance torque needed for controlled door movement and proper opener operation.

Features & Benefits

• .2625″ wire diameter with blue wire-size identification.

• 2″ inside diameter.

• 33.5″ unwound spring-body length, excluding cones.

• Left-wind configuration.

• Winding and stationary cones installed.

• Coated, oil-tempered wire.

• Stenciled and color-coded for identification.

• Standard-cycle spring listed for a minimum 10,000-cycle application when properly selected.

A cycle consists of one full opening and closing. Service life varies with loading, operating turns, installation quality, maintenance, and environmental conditions.

Specifications

Common Applications

For replacing a matching torsion spring in a compatible sectional overhead door assembly. Final suitability depends on measured door weight, door height, cable drums, track layout, and the other spring when used in a pair.

Wire diameter alone cannot establish the door weight this spring can counterbalance.

Compatibility & Measurement

Match the .2625″ wire diameter, 2″ ID, 33.5″ unwound coil-body length, and left-wind direction. Verify cone fit, shaft dimensions, stationary mounting, and available operating clearance.

This 33.5″ spring is not interchangeable with a 37.5″ or 40″ spring merely because the wire diameter and ID match. Body length affects torque per turn and the resulting door balance.

Measure the spring body without the cones. The blue marking is a wire-size identification aid and must not replace accurate measurements.

Pairing & Higher-Cycle Options

On a two-spring installation, the pair must provide the required combined output. Some systems use equal-size opposite-wind springs, while others require unequal sizes.

If one spring fails, have the companion evaluated for age, condition, and correct sizing. A higher-cycle replacement requires a calculated alternative that preserves the required torque characteristics and fits the shaft.

Changes to lift geometry or cable drums require a new compatibility assessment.

Installation & Safety

Installation should be performed by a trained garage door technician. Torsion springs, drums, and lifting cables can release dangerous stored energy if handled incorrectly.

Do not loosen loaded spring hardware. After replacement, verify manual door balance, cable tracking, clearances, and opener safety reversal before returning the door to normal service.

Confirm your measurements and order this SSC 33.5-inch left-wind spring. Send us your existing spring and door-system details if you need help checking compatibility.

SSC .2625 x 2″ ID x 33.5″ Left-Wind Torsion Spring – Blue
American-made SSC torsion spring with installed cones and coated, oil-tempered wire. Verify exact dimensions and left-wind configuration before ordering.