SSC .2500 x 2″ ID x 120″ Torsion Spring – Left Wind – Gold

🇺🇸 Made in USA

Manufactured by Service Spring Corporation (SSC), this long-length torsion spring is listed with .2500″ wire, a 2″ inside diameter, a 120″ body length, and left-wind coils.

The 120-inch measurement equals 10 feet of spring-body length. It is not a door-height rating. This listing requires careful application and supplied-configuration verification before purchase.

Features & Benefits

• .2500″ wire diameter with gold wire-size identification.

• 2″ inside diameter.

• Listed spring-body length: 120″.

• Left-wind configuration.

• Coated, oil-tempered wire.

• Long-length format for professionally specified applications.

• Existing listing identifies winding and stationary cones as included; confirm the supplied configuration before ordering.

Specifications

Application & Length Verification

This item should be selected by a qualified technician who has established the required spring dimensions and operating characteristics.

Before ordering, confirm whether the supplied item is intended as a complete 120-inch spring assembly or long-length material for professional preparation. Do not assume it is a ready-to-install replacement for a typical residential door.

Any change to the finished spring length changes its operating characteristics. It is not a universal spring that can be shortened to an arbitrary dimension.

Compatibility

Verify wire diameter, inside diameter, final required body length, winding direction, shaft compatibility, cone arrangement, and stationary mounting.

Available shaft space must accommodate the complete assembly and its operating clearances. Gold paint is a wire-size identification aid, not a lifting-capacity rating.

Door weight, height, cable drums, lift configuration, and any companion spring must be included in the selection calculation.

Cycle Life & Pairing

The listing carries a general minimum 10,000-cycle statement. For a long-length item, the intended finished configuration, loading, and operating turns must be verified before assigning an application-specific cycle rating. Length alone does not guarantee higher cycle life.

For paired systems, confirm the combined torque of the complete spring arrangement. High-lift, vertical-lift, or drum changes require separate calculations.

Installation & Safety

Selection, any preparation, and installation should be performed by a trained garage door professional. Do not cut, alter, wind, or install this spring without an approved specification and suitable equipment.

Torsion springs store dangerous energy. Never loosen loaded cones, drums, cables, or bottom fixtures. The completed system must be checked for balance, clearances, cable tracking, and safe operation.

Contact us before ordering to confirm the 120-inch supplied configuration, cone arrangement, and suitability for your professionally specified application.

SSC .2500 x 2″ ID x 120″ Left-Wind Torsion Spring – Gold
American-made SSC long-length torsion spring with coated wire. Confirm supplied configuration, finished requirements, and compatibility before purchasing.