Right Wind Garage Door Torsion Spring — .2187 Wire × 1.75″ ID × 28″ Long, Coated, with Cones

Spring Specifications

• Made in the USA
• All springs rated for an industry standard minimum lifecycle of 10,000 cycles
• Springs come with winding and stationary cones installed and are stenciled and color coded for easy identification
• Coated & oil tempered wire

Spring Specifications

• Wind Direction: Right Wind (RW)
• Wire Size: .2187 inch
• Inside Diameter: 1.75 inches
• Spring Length: 28 inches
• Wire Type: Oil-tempered steel
• Finish: Protective coated finish
• Cones: Winding and stationary cones installed
• Standard Cycle Rating: Minimum 10,000 cycles
• Manufactured in the USA

Product Description

This right wind garage door torsion spring is designed to replace a worn, damaged, or broken spring in a compatible residential sectional garage door torsion system.

The spring is manufactured from durable oil-tempered steel wire and features a protective coated finish for cleaner handling and improved corrosion resistance. It measures .2187 inch in wire diameter, 1.75 inches in inside diameter, and 28 inches in overall length.

The winding and stationary cones are already installed, allowing the spring to be prepared for professional installation after all required dimensions and lifting specifications have been confirmed.

Size / Specification Chart

Common Uses

• Replacing a broken garage door torsion spring
• Residential sectional garage doors
• Standard overhead garage door torsion systems
• Single-spring torsion assemblies
• Dual-spring torsion assemblies
• Professional garage door repair and maintenance

Compatibility & Fitment

This spring should only be used when its wind direction, wire diameter, inside diameter, spring length, and lifting capacity match the requirements of the garage door.

The existing spring should be physically measured before ordering. Door weight, door height, cable drum size, track configuration, number of springs, and torsion-system design must also be considered.

Spring dimensions alone do not guarantee correct compatibility.

Important Matching Notes

Confirm the following specifications before ordering:

1. Wind direction: Right Wind
2. Wire diameter: .2187 inch
3. Inside diameter: 1.75 inches
4. Spring length: 28 inches

A right wind spring is commonly installed on the left side of the center support bracket when viewed from inside the garage looking outward. Always inspect the existing torsion spring arrangement before selecting a replacement.

Do not select a replacement spring based only on its painted color code. Physically measure the spring and verify the required lifting specifications.

Installation Notes

Garage door torsion springs must be installed and adjusted using properly sized professional winding bars. Screwdrivers, pliers, socket extensions, and other improvised tools must never be used to wind or unwind a torsion spring.

After installation, the garage door must be tested for proper balance throughout its complete range of travel. An incorrectly selected or adjusted spring can cause the door to rise unexpectedly, close rapidly, damage the opener, or place excessive stress on other garage door components.

Safety Warning

Garage door torsion springs operate under extreme mechanical tension. Improper installation, adjustment, or removal can cause serious injury, death, or property damage.

Installation should be performed only by a trained garage door technician using the correct tools, measurements, safety equipment, and spring-calculation procedures.

Right Wind Garage Door Torsion Spring .2187 × 1.75″ × 28″ with Cones

Shop a coated right wind garage door torsion spring with .2187-inch wire, 1.75-inch inside diameter, 28-inch length, and installed winding and stationary cones.